ブックタイトルTASCO CATALOG 2015

概要

TASCO CATALOG 2015

HIGH-PERFORMANCE VACUUM PUMPS(FOR CONVENTIONAL & NEW REFRIGERANTS)Prevention of Reverse Flow of the Vacuum Pump OilREFRIGERANT OIL FORTHE HFC SYSTEMMIXING OFDIFFERENT TYPES OF OILPROBLEMSOLUTIONSSynthetic OilReverse flow ofthe vacuum pump oil(mineral oil)●POE (Polyol ester)●PVE (Poly vinyle ether), etc.To the HFCsystemThere is a high danger ofcausing damage tothe HFC system.(clogging the capillary tubes,burning the compressor)Vacuum pump withcheck valve (Can alsobe used for theconventional system)Ultra-Mini Two-Stage Vacuum Pump(with oil flow back prevention function)MechanismTwo-Stage method makesHigh Ultimate Vacuum 38micron◆◆◆◆◆◆Item no.TA150SB-2-220Rotor method...Two-stage◆Running method...DirectPumping speed...40 l/min◆Ultimate vacuum...38 micronRotation per minute...3200 r.p.m◆Power, motor...220V, 200WOil...140ml◆Suction port...5/16 flareSize, weight...100(W) x 260(D) x 170 (H)mm, 4.3kgAttachments...Vacuum pump oil, 5/16 female x 1/4 male adapterHigh Quality Two-stage Vacuum Pump(4 pole motor)(Oil flow back prevention valve attached)Exhaust ValveHigh PressureWith Gas Ballast ValveIntake PortGas Ballast Valve prevent deterioration of oiland capacity deterioration of a vacuum pumpand makes its life longer.Two rotor connected to each other cancommpresse intake air better andexhaust.Therefore, there would be a big pressuredifference between Exhaust Port andIntake Port,which can obtain higher ultimatevacuum than One-Stage method.Another reason for obtaining highultimate vacuum is this method canrotate and intake air somoothly.So that there would not be load backpressure on the rotor for the first stageHigh Quality Two-stage Vacuum Pump(Oil flow back prevention valve attached)◆◆◆◆◆◆◆◆◆◆◆◆Item no. TA150XA-220Rotor method...Two-stage◆Running method...DirectPumping speed...48 l/min(60Hz), 40.8 l/min(50Hz)Ultimate vacuum...15 micronRotation per minute...1720r.p.m (60Hz), 1440r.p.m(50Hz)Power, motor...220V, 210W◆Oil...350ccSuction port...1/4 male flare, 5/16 female flare (for R410a)Size, weight...330(W) x 115(D) x 225 (H)mm,9.5kgAttachments...Vacuum pump oil 500cc (TA117-1)Attached with a oil flow back prevention valve, so can vacuum any refrigerant cycle.Can obtain high vacuum due to the 2 stage rotar method.By adopting the 4 pole motor, the pump can be run long hours; can vacuum HFCequipments and low temperature equipments.Can vacuum from small to large size air conditioner / refrigerant systems.◆◆◆◆◆◆◆◆◆◆◆◆Item no. TA150XX-220Rotor method...Two-stage◆Running method...DirectPumping speed...270 l/min (60Hz), 225 l/min (50Hz)Ultimate vacuum...12 micronRotation per minute...3440r.p.m (60Hz), 2880r.p.m(50Hz)Power, motor...220V, 400W◆Oil...570ccSuction port...1/4 male flare, 3/8 male flareSize, weight...380(W) x 160(D) x 285 (H)mm ,14.8kgAttachments...Vacuum pump oil 500cc (TA117-1)1/4 female flare x 5/16 male flare adapter.2 pole motor enables lightweight high power.Equipped with oil flow back prevention valve so the pump can be used on both new(HFC) and conventional (CFC, HCFC) refrigerants.When vacuuming large units, use the 3/8 hose for faster vacuumConfidently presenting our high quality vacuum pump!!All TASCO vacuum pumps are tested before shipment.Here are our testing procedures.1.Visual Inspection 2.Running Test 3.Current Check 4.Ultimate Vacuum TestWe check tosee if there areany cracks,breakage etcto the pump.We test to seeif the pumpshave anystarting failuretrouble.We test thestarting currentand runningcurrent of thepump.We check to seeif the ultimatevacuum withinspecification isreached.17